Tools Required For Assembly
|
|
Joining two Pool Entry Systems.
|
When joining two units
together, the deck connectors will not be used. Assemble both units
and position the in-pool unit in the desired location, after filling
it in the same manner as step #12. Allow approximately two (2) inches
of clearance between the side of the pool (pool liner) and the Entry
System. Make any necessary height adjustments to ensure that all four
(4) threaded adjustors are supporting the unit, that the unit is level
and does not wobble, and that the underside of the top step is about
(1/2) inch above the pool top seat. The outside unit should rest on
cement patio blocks. Position and level the outside unit so that both
units can be joined using the six (6) 1/4-20 x 1" machine screws and
hex nuts. The hex nuts should be on the outside of the fastening flange
of the side panels (See diagram on pg 2). Press the large plugs into
the fill opening of the outside unit. It is not necessary to fill the
out
|
Optional mounting method when deck height is greater than (54-1/2) inches. Adjust the height of the entry system so that the top step, at minimum, reaches the face board of the deck, however, the height of the bottom surface of the top step must not exceed (54-1/2) inches. Cut a piece of 2 x 4 pressure treated lumber (28-1/4" long) and place it edge down on the top step between the two flanges of the side panels. Secure in place with four #10 x 1-1/4" screws (not provided) through the two lower holes in each of the mounting flanges of the side panel. After securing the 2 x 4 to the unit, position the unit so that the 2 x 4 meets the face board of the deck. It can then be secured in place using wood lag screws. Three 2-1/2" long lag screws are required (Lag screws not provided). |
|
Removal and storage of Pool Entry System: In cold climates the Entry System must be removed from the pool and drained to prevent freezing and cracking. To remove the unit disconnect it from the deck (or the outside unit), pull large plugs and tip it so that some of the water drains from the large fill openings. Once the unit is lighter it will become buoyant so that it can be turned onto its side and the bottom drain caps and plugs can be removed. With the unit on its side, slowly pull the Entry System from the water allowing the water to drain out of the unit. Once the unit is out of the pool be sure that all the water drains out. If desired the unit can be disassembled for winter storage. Use a flat blade screwdriver to remove the locking wedges and carefully pull the side panels away from the steps. (Be sure to save all caps and locking wedges for reassembly). |
|
SAFETY RULES
*Warning: Exceeding the recommended weight requirement may cause the unit to fail. *DANGER: Never use an electric drill in or around the pool |
|